by homerjon_mistaway | Dec 31, 1969 | Gen 3 – Setup
Gen 3 is designed to recognize problems with its operations and display error messages that facilitate quick troubleshooting. These error conditions suspend the operation of the unit until the error is clear by pressing and holding the Red MENU/Stop button for 5...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 – Setup
iMist2 is our second generation wireless technology that allows our dealers to monitor and manage misting units over the internet. For an introduction to iMistAway, see iMist – Intro Video (8:41) For installation instructions, see iMist2: Setup Part 1-...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 – Setup
Pictured: Gen 3 Zone Kit, mounting screws and length of 1/4″ tubing. 1. Disconnect power to the unit. The zone kit will be recognized when the controller boots up after the Zone Kit is connected. 2. Remove the black plastic plug from access port and push...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 – Setup, Gen 3 – Setup
Content coming soon! Establish Optional Wind Sensor SET-UP Menu, SEN If sensor installed, ON. Otherwise, set to OFF. Set Max Wind Speed (wind sensor required) SET-UP Menu, WND Set max wind speed Verify ALT value is...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 – Setup
Download the Gen 3 Operating Manual for printing (English) See Gen 3: Setup Checklist Watch Setting Up a Gen 3 Tankless Unit (13:38) See Controller: “Learning” the iMist2-ready Handheld Remote Transmitter See Gen 3: Approved Insecticides See Gen 3...
