by Jim Jackson | May 20, 2020 | Gen 1.3 - Troubleshooting, Gen 3 - Troubleshooting
Common Root Causes: Unit does not recognize remote transmitter. See Controller: “Learning” the iMist2-ready Handheld Remote Transmitter System Mode is set to OFF. Reset System mode to AUTO mode or REM (or ON)....
by Jim Jackson | May 20, 2020 | Gen 1.3 - Troubleshooting, Gen 3 - Troubleshooting
Potential Root Causes: Unit does not recognize remote transmitter. See Controller: LRNing the Remote Transmitter System Mode is set to OFF. Reset System mode to AUTO mode or REM (or ON). See Controller: Setting...
by Jim Jackson | May 13, 2020 | Gen 1.3 - Troubleshooting, Gen 3 - Troubleshooting
Before troubleshooting Confirm the zone kit has been properly installed and the controller has been programmed. See Gen 1.3: Zone Kit instructions or Gen 3+ Zone Kit Instructions Confirm the nozzle circuits for Zone 1 and Zone 2 are independent and not tied together....
by Jim Jackson | May 11, 2019 | Controller & Remote, Gen 3 - Troubleshooting
If the display on the Gen 3/3+ controller is blank, and you are certain there is power to the outlet, either the fuse protecting the controller has blown due to a power surge, or a component in the misting unit is shorted, or the controller has otherwise failed. A...
by Jim Jackson | Dec 21, 2018 | Gen 3 - Troubleshooting
See Gen 3: Controller displays “MIST”, but Nozzles Not Misting 1. Ensure intake filter is clean Access batch tank. See Gen 3: Access Components by Repositioning Shroud If filter is clogged, clean and replace. Run INSpect, if nozzles not misting,...