by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
Cause: Unit has calculated zero remaining volume in the bottle and must be refilled. See Gen 3: Refill Checklist
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Troubleshooting, Gen 3 - Troubleshooting
Potential Causes: System Mode is set to OFF or REM (or ON) and should be set to AUTO EVERYDAY or AUTO-CUSTOM. See Controller: Setting System Mode There are no AUTO MIST cycles defined. See Controller: Setting AUTO MIST Cycles The controller has calculated that the...
by homerjon_mistaway | Dec 31, 1969 | Controller & Remote, Gen 1.3 - Troubleshooting, Gen 3 - Troubleshooting
Unit displays NOZ00 and will not mist. Cause: Nozzle count in the SET-Up Menu is not set. Clear by pressing and holding the Red MENU/STOP button for 5 seconds. Press the Red MENU/STOP button to display the triangular cursor, ►, by DAY/TIME position on left side of...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
Because the Level Displayed is based on an internal calculation and not on an actual sensor measurement, it is possible there may be a difference between the displayed level and the actual level in the bottle. See Gen 3: How Bottle Level Display Works. Check Refill...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
Most Common Cause Inlet solenoid valve is jammed in the open position. This is usually a result of sediment in the water line This is preventable by using the Inlet Water Filter (Part #10860) shipped with the unit. Other Potential Causes Float switch is not...
