by Jose Marcano | Mar 22, 2022 | Nozzle Circuit
This case is typically caused by what we refer to as a “Line-Fill Leak”. These types of “leaks” are notoriously difficult to troubleshoot because they generally can’t be seen and are difficult to reproduce while on-site. The root cause for these types of leaks is...
by Jose Marcano | Mar 22, 2022 | iMistAway
The iMist gateway is connected to the internet but it is not communicating with the node on the misting unit. Potential Cause: The node’s processor has locked up or gotten “stuck” The gateway or node has failed. Troubleshooting: To confirm the issue, open the...
by Jose Marcano | Mar 22, 2022 | Nozzle Circuit
For pesky spiders, an automated misting system can provide some of the best spider control available. Traditionally, spiders are hard to control with periodic barrier treatments applied by a technician due to the small contact area of their feet and their aggressive...
by Jose Marcano | Mar 22, 2022 | Nozzle Circuit
A nozzle drips when the pressure in the tubing is in a range where it is too low for the nozzles to atomize the fluid through the orifice but too high for the check valve in the nozzle to close. How it should work: At the end of a mist cycle, when the controller stops...
by Jose Marcano | Mar 22, 2022 | Insecticide
Use this troubleshooting guide if you think your misting system is not as effective as it once was. Fouled Nozzles This is the most common root cause for efficacy issues. Fouled Nozzles lead to reduced output volume per nozzle during a mist (flow rate should be 40...
